Med-X Products now offers several products to satisfy your cassette, CR, or DR panel positioning needs.

We have mobile cassette holders, mobile DR panel holders and table-top holders.

(Please note: DR detectors are generally heavy and care should be taken during cross-table procedures to insure stability, even when using a holder. We cannot be responsible for dropped detectors.)

Mobile CR plate/cassette holder: ALL MOBILE UNITS INCLUDE:

• Vertical range from bottom of cassette/plate:
• floor-to-54".
• Arm slides vertically on 60" chromed steel post.
• Holder locks onto post with spring-loaded pin.
• 18" square steel shelf base with protective mat.
• Heavy base prevents tipping.
• E-Z-Roll swivel casters (two are locking).
• Neutral Almond baked enamel finish.
• Fixed arm length provides maximum stability.
• Fully articulating holder.
• Ships in two cartons: 1@15 lbs, 1@70 lbs.

 

Part # MCH-33B

 

Table-top Cassette and CR plate holder:

• Eliminates hand held plate/cassette hazards.
• Enhances Technologist’s Safety.
• Securely holds plate/cassette in a stable,upright position.
• Both 6" wide channels adjust to fit cassette.
• Holds up to 14" x 17" (35 x 43cm) cassettes.
• Accepts Grid Cassettes and CR-plates (channel is 11⁄4"d).
• Base plate slides under patient or pad.
• Upper channel includes a rotating R & L marker.

Both Upper & Lower Channels are lined with rubber to keep all types of plates/cassettes in a stable position.

Shipping weight: 7 lbs.

Part # TA35

Use Pic: A8

 

 

SLAPPER NON-SLIP CASSETTE HOLDER

This lightweight device is used for cross-table laterals and adapts to most cassette sizes. Part #: 211

 

 

 

 

 

 

 

WEIGHT BEARING CASSETTE HOLDER

Developed to facilitate longitudinal arch and lateral projection studies. Part #:199